-
Firmly press the product to the wall
and the ceiling, make a mark
on the bottom edge of the product.
-
Make a mark on the bottom edge of the product.
-
By use of chalkline to connect the marks
on the perimeter of the room.
-
Use the anglemeter
to measure the angles of the room.
-
Using a mitre saw,
cut out the element to the appropriate angle.
In a room with 90° angles a mitre box
or a handsaw can be used.
-
Apply evenly on the mounting surface
Multipurpose Adhesive along the whole length.
The thickness of the applied adhesive
should be 3-5 mm.
-
Attach the item to the place of installation,
using as benchmarks the previously
made marks on the wall.
Push the entire length of the item
so the adhesive exudes from the entire plane.
-
Using screw gun , fix the product
by self taping screws (Step = 600мм).
-
Remove the excess of adhesive
with a spatula immediately after Fixation
by Self tapping screw.
-
Wipe the area of the junction
with a wet clothwith Acetone
in case of using Multipurpose Adhesive.
-
Apply Evroplast for Bonding joints
onto the bottom side of the balusters.
-
Mounting of the adjoining cornice:
remove the dust and other impurities
from the surface of the abutting cornices
with a wet cloth.
-
Bonding of the joints:
apply Adhesive for bonding joints on the side
surface of the already mounted cornice.
-
Apply Multipurpose or Assembly Adhesive
to the surfaces adjoining
of the next cornice
-
Press the cornice to the wall and ceiling
until the adhesive shows on the whole surface
of the junction. By moving the product along the wall
press to the next cornice till Adhesive
will appear at the junction.
-
Fix the junction area by construction stapple gun.
-
Remove the excess of adhesive
with a spatula immediately after bonding.
-
Wipe the area of the junction with a wet cloth.
Wet the cloth with water if Assembly Adhesive is used
and with Acetone in case of using Multipurpose Adhesive
or Adhesive for bonding joints.
-
Continue the process of installation
of the next cornice.
-
Wait for 3 hours and remove clamps
from area of the junction.
-
Process area of the junction
with Fine grain abrasive paper
until you get smooth surface.
-
Fill the treated area and places where you used
self taping screws with fine-grained,
water-soluble filler for interior works.
Wait for 60 minutes and repeat Step #21 if needed,
until you get a flat surface.
-
Fill the spaces in the junction area
between the cornice and the walls/ ceiling,
where the adhesive has not shown on a surface.
-
Wipe the area of the junction with a wet cloth.
Wet the cloth with water if Assembly Adhesive
is used and with Acetone in case of using
Multipurpose Adhesive or Adhesive for bonding joints.
-
Paint the cornice following the instruction
of paint producer, starting with the corners
of the elements (room).